Serial wan interface card

This section describes the HWICs and tells how to connect them to a network. The maximum data rate supported is 8 Mbps per port. The maximum data rate supported is kbps per port synchronous. Data rates of up to There is no room for individual LEDs to indicate transmit or receive activity, or clock status. This section describes the preparation necessary before connecting a Cisco serial HWIC to the network. Ensure that the equipment you are working with is properly grounded. Use the correct cable for your serial HWIC.

Six types of smart serial cables are available:. All of these serial cables provide a pin plug at the interface card end. See Figure Figure 11 Quad Serial Cable. The 8-port and port asynchronous HWICs use an octal cable, consisting of a pin connector on the interface card end and eight RJ45 connectors on the system end.

This cable is available in DTE format only. Figure 12 Octal Serial Cable. To connect the serial HWIC to the network, follow these steps:.

Latest Contents. It is our pleasure to officially announce the finalists in the IT Blog Awards. Now we are looking to YOU, our amazing tech community, to weigh in. Check out the amazing educational content we've uncovered and vote for your favorites before Friday, Fe Created by Mohamed Alhenawy on AM. SDN is a centralized approach to network management which abstract OSPF inter-area loop prevention and discard route issues.

Created by meddane on PM. Basic configuration of all routers: R1:ipv uni! Created by tgambus on AM. Created by Mohamed Alhenawy on PM. Ask a Question. Find more resources. Blogs Networking Blogs Networking News. Project Gallery. Supports 8 Mbps on all ports simultaneously on , , and No restrictions.

Maximum six ports at 8 Mbps each. Note: The X. For clock rates beyond 4 MHz, V. The following table lists the part number for the cables that can be used with the WIC-2T card. Contact Supplier. CN Guangzhou Mainetwork Co.